using Epoxy paint to Your Garage surface

Many times we don’t believe about our garages or pay much attention to the look of them. They are merely a place to park the cars and store the extra boxes of Holiday accessories and such. However, like any other room in your house your storage floor must be taken health care of.
Because of the utilize it gets, coupled with normal water, gas and essential oil that will inevitable be spilled after it, garage floor coverings can easily become destroyed and begin to fall apart over time of use. Epoxy coating is one way to your garage floor challenge. Epoxy covering applies a level of sealant and protectant to your concrete garage floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front prep before beginning. The most important step in the process is ensuring the floor you will apply the epoxy finish onto is free from moisture, residual car paint and doesn’t have a concrete sealer or other finishing applied to it.
To check for moisture, take a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two times and then remove and look for any moisture collecting privately of the plastic material facing the ground. If moisture is present, than an epoxy floor finish is not suited as epoxy requires a dried up surface to properly bond with the floor coverings.
Next, we’ll test to make certain the flooring does not have a sealant already put on it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of normal water and pour it straight onto the existing flooring. It will soak into the floor in a reasonable timeframe. If it beads or just sits together with the flooring then the floor has probably already been sealed or is made up of oil pollutants. Epoxy floor coverings is not suited to cement floors which have already been covered or contain any type of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing an area of your storage area floor for suitability to putting in epoxy floor you can color a small area with regular, oil-based enamel. If this test area endures for several a few months then chances are an epoxy layer will last as well. However, if you decide to proceed with making use of the epoxy coating you will need to eliminate this enamel covering that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *