using Epoxy paint to Your Garage floors

Often we don’t believe about our garages or pay much attention to their appearance. They are simply just a spot to park the vehicles and store the excess boxes of Christmas designs and such. However, like any other room in your house your car port floor needs to be taken care and attention of.
Because of the use it gets, combined with normal water, gas and oil that will inevitable be spilled after it, garage floor coverings can simply become damaged and begin to break apart over time of use. Epoxy layer is one way to your garage floor challenge. Epoxy coating applies a layer of sealant and protectant to your concrete garage floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front prep before beginning. The main step in the procedure is ensuring the floor you are going to apply the epoxy finish onto is free of moisture, residual car paint and doesn’t have a cement sealer or other concluding put on it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting privately of the vinyl facing the floor. If moisture exists, than an epoxy flooring covering is not suitable as epoxy requires a dried up surface to properly bond with the flooring.
Next, we’ll test to make certain the flooring doesn’t have a sealant already put on it. This test will also check for the presence of oils in the cement as well. Take a cup of water and pour it straight onto the existing flooring. It will soak into the floor in an acceptable amount of time. If it beads or perhaps sits together with the flooring then your flooring has probably already been sealed or is made up of oil contaminants. Epoxy flooring is not well suited for cement floors which may have already been covered or contain any kind of olive oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your storage floor for suitability to putting in epoxy floor coverings you can paint a small area with regular, oil-based teeth enamel. If this test area will last for several weeks then it is likely an epoxy finish will last as well. However, if you opt to proceed with applying the epoxy layer you will need to remove this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *