using Epoxy paint to Your Garage Flooring

Many times we don’t believe about our garages or pay much attention to the look of them. They are merely a place to park the vehicles and store the extra boxes of Holiday accessories and such. However, like any other room in your house your garage floor must be taken treatment of.
Because of the make use of it gets, combined with water, gas and oil that will inevitable be spilled after it, garage flooring can easily become ruined and get started to fall apart after a few years useful. Epoxy finish is one solution to your garage floor challenge. Epoxy covering applies a part of sealant and protectant to your concrete storage floor to make it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The main step in the procedure is ensuring the floor you will apply the epoxy coating onto is free of moisture, residual car paint and does not have a cement sealer or other finishing applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the vinyl facing the ground. If moisture exists, than an epoxy floor coverings layer is not ideal as epoxy requires a dried surface to properly connection with the flooring.
Next, we’ll test to ensure the flooring doesn’t have a sealant already put on it. This test will also check for the presence of oils in the concrete as well. Take a cup of drinking water and pour it immediately onto the existing flooring. It should soak into the floor in an acceptable timeframe. If it beads or maybe sits together with the flooring then the flooring has probably already been sealed or consists of oil impurities. Epoxy floor is not well suited for cement floors which may have already been covered or contain any kind of essential oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your garage area floor for suitability to installing epoxy floor you can color a tiny area with regular, oil-based enamel. If this test area is maintained for several months then it is likely an epoxy covering will last as well. However, if you decide to proceed with applying the epoxy coating you will need to eliminate this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *