using Epoxy paint to Your Garage Flooring

Many times we don’t believe about our garages or pay much focus on the look of them. They are merely a place to park the vehicles and store the extra boxes of Xmas decor and such. However, like any other room in your house your garage area floor needs to be taken good care of.
Because of the put it to use gets, combined with drinking water, gas and engine oil that will inevitable be spilled upon it, garage floor coverings can simply become broken and start to fall apart over time of use. Epoxy coating is one method for your garage floors challenge. Epoxy covering applies a part of sealant and protectant to your concrete car port floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings takes a little up-front preparation before beginning. The most important step in the procedure is making sure that the floor you will apply the epoxy layer onto is free of moisture, residual car paint and does not have a cement sealer or other concluding applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting privately of the plastic material facing the ground. If moisture is present, than an epoxy flooring coating is not appropriate as epoxy needs a dried surface to properly bond with the floor.
Next, we’ll test to make certain the flooring does not have a sealant already put on it. This test will also check for the occurrence of natural oils in the concrete as well. Take a cup of drinking water and pour it directly onto the existing flooring. It should soak in to the floor in an acceptable amount of time. If it beads or perhaps sits on top of the flooring then your floor has probably already been sealed or contains oil pollutants. Epoxy floors is not ideal for cement floors which may have already been closed or contain any kind of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing an area of your car port floor for suitability to installing epoxy floors you can coloring a small area with regular, oil-based enamel. If this test area continues for several weeks then chances are an epoxy layer can last as well. However, if you decide to proceed with applying the epoxy coating you’ll need to remove this enamel finish that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *