using Epoxy paint to the Garage floors

Often we don’t believe about our garages or pay much focus on the look of them. They are merely a place to park the automobiles and store the extra boxes of Holiday accessories and such. However, like any other room in your own home your garage floor must be taken health care of.
Due to the utilize it gets, coupled with water, gas and olive oil that will unavoidable be spilled after it, garage floor can certainly become ruined and commence to fall apart after a few years of use. Epoxy coating is one method for your garage floor challenge. Epoxy finish applies a level of sealant and protectant to your concrete car port floor to make it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings requires a little up-front planning before beginning. The main step in the procedure is ensuring the ground you are going to apply the epoxy coating onto is free of moisture, residual paint and does not have a cement sealer or other completing put on it.
To test for moisture, take a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting privately of the vinyl facing the ground. If moisture is present, than an epoxy floor coverings layer is not suitable as epoxy needs a dry surface to properly connection with the flooring.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also check for the presence of oils in the concrete as well. Take a cup of water and put it immediately onto the prevailing flooring. It will soak into the floor in an acceptable amount of time. If it beads or maybe sits on top of the flooring then the flooring has probably already been sealed or contains oil contaminants. Epoxy floors is not suited to cement floors which may have already been covered or contain any kind of engine oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your car port floor for suitability to putting in epoxy flooring you can color a little area with regular, oil-based enamel. If this test area will last for several months then it is likely an epoxy covering can last as well. However, if you decide to proceed with applying the epoxy finish you will need to eliminate this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *