using Epoxy paint to the Garage floor

Often we don’t believe about our garages or pay much focus on the look of them. They are merely a spot to park the vehicles and store the extra boxes of Holiday decor and such. However, like any other room in your house your garage floor needs to be taken health care of.
Due to the utilize it gets, combined with normal water, gas and essential oil that will inevitable be spilled upon it, garage floor coverings can certainly become harmed and start to fall apart after a few years of use. Epoxy finish is one answer to your garage floor coverings challenge. Epoxy layer applies a coating of sealant and protectant to your concrete garage area floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings requires a little up-front planning before beginning. The most important step in the process is ensuring the ground you will apply the epoxy covering onto is free from moisture, residual paint and does not have a cement sealer or other completing applied to it.
To check for moisture, have a sheet of plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting privately of the vinyl facing the floor. If moisture is present, than an epoxy floors covering is not ideal as epoxy needs a dry surface to properly bond with the flooring.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also check for the presence of natural oils in the concrete as well. Take a cup of normal water and put it directly onto the existing flooring. It will soak into the floor in a reasonable timeframe. If it beads or simply sits on top of the flooring then the floor has probably recently been sealed or contains oil impurities. Epoxy floors is not ideal for cement floors that have already been sealed or contain any kind of oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your car port floor for suitability to putting in epoxy floors you can paint a little area with regular, oil-based enamel. If this test area lasts for several calendar months then chances are an epoxy covering can last as well. However, if you opt to proceed with applying the epoxy layer you will need to eliminate this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *