using Epoxy paint to any Garage floors

Many times we don’t believe about our garages or pay much attention to their appearance. They are simply just a spot to park the autos and store the excess boxes of Christmas designs and such. However, like any other room in your own home your car port floor must be taken attention of.
Because of the utilize it gets, coupled with drinking water, gas and olive oil that will inevitable be spilled upon it, garage floor coverings may easily become broken and start to fall apart over time of use. Epoxy finish is one solution to your garage flooring challenge. Epoxy covering applies a covering of sealant and protectant to your concrete garage area floor to make it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings takes a little up-front prep before beginning. The main step in the process is making sure that the floor you will apply the epoxy layer onto is free from moisture, residual coloring and does not have a cement sealer or other concluding applied to it.
To check for moisture, have a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting privately of the clear plastic facing the ground. If moisture is present, than an epoxy floors finish is not suited as epoxy needs a dried out surface to properly relationship with the floors.
Next, we’ll test to make sure the flooring doesn’t have a sealant already applied to it. This test will also check for the presence of oils in the concrete as well. Have a cup of drinking water and put it directly onto the prevailing flooring. It should soak in to the floor in a reasonable timeframe. If it beads or just sits together with the flooring then the floor coverings has probably recently been sealed or is made up of oil contaminants. Epoxy floor coverings is not suitable for cement floors that contain already been covered or contain any type of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your garage floor for suitability to setting up epoxy flooring you can paint a little area with regular, oil-based enamel. If this test area can last for several weeks then it is likely an epoxy covering can last as well. However, if you decide to proceed with making use of the epoxy coating you will need to eliminate this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *