using Epoxy flooring to Your Garage floors

Many times we don’t believe about our garages or pay much focus on their appearance. They are simply just a location to park the automobiles and store the excess boxes of Christmas accessories and such. However, like any other room in your house your garage area floor must be taken care and attention of.
Due to the use it gets, combined with drinking water, gas and essential oil that will inevitable be spilled upon it, garage floor coverings can certainly become damaged and begin to fall apart after a few years useful. Epoxy coating is one way to your garage floor coverings challenge. Epoxy coating applies a part of sealant and protectant to your concrete garage area floor to help it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front prep before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy coating onto is free of moisture, residual coloring and doesn’t have a concrete sealer or other concluding applied to it.
To test for moisture, take a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting privately of the plastic facing the ground. If moisture is present, than an epoxy floor coating is not appropriate as epoxy needs a dry surface to properly bond with the floor.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also check for the occurrence of natural oils in the cement as well. Take a cup of normal water and pour it directly onto the existing flooring. It should soak into the floor in an acceptable amount of time. If it beads or maybe sits together with the flooring then your flooring has probably already been sealed or has oil contaminants. Epoxy floors is not suited to cement floors which have already been closed or contain any type of olive oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing a location of your car port floor for suitability to putting in epoxy floor coverings you can color a little area with regular, oil-based teeth enamel. If this test area continues for several weeks then chances are an epoxy layer will last as well. However, if you decide to proceed with applying the epoxy layer you’ll need to remove this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *