using Epoxy flooring to Your Garage Flooring

Often we don’t believe about our garages or pay much attention to their appearance. They are simply just a destination to park the autos and store the extra boxes of Christmas designs and such. However, like any other room in your house your storage floor needs to be taken good care of.
Due to the use it gets, combined with water, gas and oil that will inevitable be spilled after it, garage floor coverings can easily become destroyed and commence to break apart after a few years of use. Epoxy layer is one answer to your garage floor coverings challenge. Epoxy covering applies a coating of sealant and protectant to your concrete garage floor to make it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings takes a little up-front preparation before beginning. The main step in the process is making sure that the floor you are going to apply the epoxy finish onto is free of moisture, residual coloring and does not have a cement sealer or other concluding put on it.
To check for moisture, have a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture exists, than an epoxy floor layer is not ideal as epoxy needs a dry out surface to properly relationship with the flooring.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of drinking water and put it straight onto the existing flooring. It should soak into the floor in a reasonable timeframe. If it beads or maybe sits on top of the flooring then your floor has probably recently been sealed or consists of oil pollutants. Epoxy floors is not suitable for cement floors that have already been sealed or contain any type of petrol residue as it will not bond.
Finally, if you are willing to spend several months testing an area of your garage floor for suitability to installing epoxy floors you can paint a little area with regular, oil-based enamel. If this test area will last for several weeks then chances are an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy covering you will need to remove this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *