using Epoxy flooring to any Garage Flooring

Often we don’t think about our garages or pay much focus on their appearance. They are merely a place to park the cars and store the extra boxes of Xmas accessories and such. However, like any other room in your house your storage floor needs to be taken attention of.
Due to the utilize it gets, coupled with water, gas and engine oil that will inevitable be spilled upon it, garage floors can simply become broken and begin to break apart over time useful. Epoxy coating is one solution to your garage flooring challenge. Epoxy layer applies a level of sealant and protectant to your concrete storage area floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front planning before beginning. The main step in the process is making sure that the floor you will apply the epoxy finish onto is free from moisture, residual coloring and doesn’t have a concrete sealer or other concluding applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting on the side of the clear plastic facing the floor. If moisture exists, than an epoxy floor finish is not suited as epoxy requires a dry surface to properly bond with the floor coverings.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the presence of natural oils in the cement as well. Have a cup of water and pour it directly onto the existing flooring. It will soak into the floor in a reasonable amount of time. If it beads or just sits on top of the flooring then your flooring has probably already been sealed or consists of oil pollutants. Epoxy floor is not ideal for cement floors which have already been closed or contain any kind of essential oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your storage area floor for suitability to setting up epoxy floor coverings you can color a tiny area with regular, oil-based enamel. If this test area can last for several months then chances are an epoxy layer can last as well. However, if you opt to proceed with making use of the epoxy covering you’ll need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *