using Epoxy flooring to a Garage floors

Often we don’t believe about our garages or pay much attention to the look of them. They are simply just a spot to park the autos and store the extra boxes of Xmas decorations and such. However, like any other room in your house your car port floor must be taken good care of.
Because of the put it to use gets, combined with drinking water, gas and olive oil that will inescapable be spilled after it, garage flooring can easily become broken and start to fall apart after a few years of use. Epoxy finish is one means to fix your garage floor challenge. Epoxy layer applies a coating of sealant and protectant to your concrete storage floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The most important step in the process is making sure that the ground you are going to apply the epoxy coating onto is free of moisture, residual coloring and doesn’t have a concrete sealer or other finishing put on it.
To test for moisture, have a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting privately of the plastic facing the floor. If moisture is present, than an epoxy flooring covering is not appropriate as epoxy needs a dried surface to properly connection with the floors.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of water and put it straight onto the existing flooring. It should soak into the floor in an acceptable amount of time. If it beads or maybe sits together with the flooring then your floors has probably already been sealed or has oil impurities. Epoxy floors is not suitable for cement floors that have already been closed or contain any type of petrol residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your garage floor for suitability to putting in epoxy floor coverings you can coloring a little area with regular, oil-based teeth enamel. If this test area lasts for several calendar months then it is likely an epoxy layer will last as well. However, if you opt to proceed with applying the epoxy layer you’ll need to remove this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *