using Epoxy flooring to a Garage floors

Often we don’t believe about our garages or pay much attention to their appearance. They are merely a location to park the autos and store the excess boxes of Christmas accessories and such. However, like any other room in your house your storage floor must be taken treatment of.
Because of the utilize it gets, coupled with drinking water, gas and oil that will unavoidable be spilled after it, garage floor coverings can easily become damaged and get started to fall apart after a few years useful. Epoxy finish is one solution to your garage floors challenge. Epoxy layer applies a covering of sealant and protectant to your concrete storage floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings requires a little up-front prep before beginning. The most important step in the procedure is ensuring the floor you are going to apply the epoxy finish onto is free of moisture, residual paint and does not have a cement sealer or other completing applied to it.
To test for moisture, have a sheet of plastic material and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting privately of the vinyl facing the floor. If moisture is present, than an epoxy floor coverings coating is not appropriate as epoxy requires a dry out surface to properly connection with the floors.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also look for the presence of oils in the concrete as well. Take a cup of drinking water and pour it immediately onto the existing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or perhaps sits together with the flooring then the floors has probably recently been sealed or has oil pollutants. Epoxy flooring is not ideal for cement floors which may have already been covered or contain any kind of essential oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing an area of your storage area floor for suitability to setting up epoxy floors you can paint a little area with regular, oil-based teeth enamel. If this test area can last for several a few months then it is likely an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy covering you will need to remove this enamel layer that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *