using Epoxy Coatings to Your Garage Flooring

Often we don’t believe about our garages or pay much attention to their appearance. They are merely a spot to park the cars and store the excess boxes of Xmas accessories and such. However, like any other room in your own home your storage area floor must be taken health care of.
Due to the make use of it gets, coupled with drinking water, gas and essential oil that will inevitable be spilled after it, garage floors can certainly become destroyed and commence to break apart over time of use. Epoxy finish is one solution to your garage floor coverings challenge. Epoxy layer applies a layer of sealant and protectant to your concrete garage floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front prep before beginning. The main step in the process is making sure that the floor you will apply the epoxy coating onto is free of moisture, residual color and doesn’t have a cement sealer or other completing put on it.
To check for moisture, take a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting privately of the clear plastic facing the ground. If moisture is present, than an epoxy floor coverings layer is not appropriate as epoxy requires a dry surface to properly bond with the flooring.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also check for the presence of natural oils in the cement as well. Have a cup of water and pour it immediately onto the prevailing flooring. It will soak in to the floor in a reasonable amount of time. If it beads or simply sits together with the flooring then your floors has probably recently been sealed or consists of oil impurities. Epoxy flooring is not suitable for cement floors which may have already been covered or contain any kind of petrol residue as you won’t bond.
Finally, if you are willing to spend several months testing a location of your garage floor for suitability to putting in epoxy floor you can coloring a small area with regular, oil-based enamel. If this test area lasts for several weeks then it is likely an epoxy finish will last as well. However, if you decide to proceed with making use of the epoxy layer you’ll need to eliminate this enamel covering that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *