using Epoxy Coatings to Your Garage floor

Often we don’t believe about our garages or pay much attention to their appearance. They are simply just a destination to park the cars and store the extra boxes of Holiday decorations and such. However, like any other room in your house your storage area floor needs to be taken care and attention of.
Due to the put it to use gets, combined with water, gas and petrol that will unavoidable be spilled after it, garage floor can certainly become destroyed and get started to fall apart after a few years useful. Epoxy layer is one treatment for your garage flooring challenge. Epoxy covering applies a layer of sealant and protectant to your concrete garage area floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor requires a little up-front prep before beginning. The most important step in the process is ensuring the floor you will apply the epoxy covering onto is free of moisture, residual color and doesn’t have a concrete sealer or other concluding applied to it.
To check for moisture, take a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting on the side of the plastic material facing the floor. If moisture exists, than an epoxy floors layer is not appropriate as epoxy needs a dry out surface to properly relationship with the flooring.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the occurrence of oils in the cement as well. Have a cup of drinking water and put it immediately onto the existing flooring. It should soak in to the floor in an acceptable amount of time. If it beads or just sits on top of the flooring then the floors has probably already been sealed or is made up of oil pollutants. Epoxy flooring is not suitable for cement floors that have already been covered or contain any type of petrol residue as you won’t bond.
Finally, if you are prepared to spend several months testing an area of your storage floor for suitability to setting up epoxy flooring you can paint a tiny area with regular, oil-based enamel. If this test area endures for several calendar months then chances are an epoxy layer will last as well. However, if you decide to proceed with applying the epoxy covering you will need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *