using Epoxy Coatings to the Garage floors

Often we don’t believe about our garages or pay much focus on their appearance. They are simply just a spot to park the cars and store the excess boxes of Christmas designs and such. However, like any other room in your house your storage floor needs to be taken care and attention of.
Because of the utilize it gets, coupled with drinking water, gas and engine oil that will inescapable be spilled after it, garage floors can easily become harmed and start to break apart after a few years of use. Epoxy coating is one method for your garage flooring challenge. Epoxy finish applies a covering of sealant and protectant to your concrete storage area floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings takes a little up-front preparation before beginning. The most important step in the process is making sure that the ground you are going to apply the epoxy covering onto is free of moisture, residual paint and doesn’t have a concrete sealer or other concluding put on it.
To test for moisture, take a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting privately of the vinyl facing the floor. If moisture exists, than an epoxy floor coverings finish is not suitable as epoxy requires a dried up surface to properly connection with the floor.
Next, we’ll test to make sure the flooring does not have a sealant already applied to it. This test will also check for the occurrence of natural oils in the concrete as well. Have a cup of normal water and put it immediately onto the prevailing flooring. It should soak into the floor in an acceptable amount of time. If it beads or just sits together with the flooring then your flooring has probably recently been sealed or has oil contaminants. Epoxy floor coverings is not suited to cement floors that contain already been closed or contain any type of engine oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your garage area floor for suitability to installing epoxy floors you can coloring a small area with regular, oil-based enamel. If this test area endures for several a few months then it is likely an epoxy coating will last as well. However, if you opt to proceed with making use of the epoxy coating you’ll need to remove this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *