using Epoxy Coatings to the Garage Flooring

Many times we don’t believe about our garages or pay much attention to their appearance. They are merely a destination to park the cars and store the excess boxes of Christmas designs and such. However, like any other room in your own home your car port floor must be taken care and attention of.
Due to the make use of it gets, coupled with drinking water, gas and engine oil that will inescapable be spilled after it, garage floor coverings can certainly become broken and start to fall apart after a few years of use. Epoxy finish is one answer to your garage floors challenge. Epoxy finish applies a coating of sealant and protectant to your concrete storage area floor to help it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The most important step in the procedure is making sure that the ground you will apply the epoxy coating onto is free from moisture, residual color and does not have a concrete sealer or other completing applied to it.
To test for moisture, take a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture is present, than an epoxy floor covering is not appropriate as epoxy needs a dried up surface to properly connection with the floor coverings.
Next, we’ll test to be sure the flooring does not have a sealant already put on it. This test will also look for the presence of oils in the concrete as well. Have a cup of normal water and pour it straight onto the existing flooring. It will soak into the floor in a reasonable amount of time. If it beads or maybe sits together with the flooring then the flooring has probably already been sealed or is made up of oil impurities. Epoxy floors is not suited to cement floors that have already been closed or contain any kind of oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing a location of your garage floor for suitability to putting in epoxy floor you can color a little area with regular, oil-based teeth enamel. If this test area continues for several months then it is likely an epoxy covering can last as well. However, if you decide to proceed with making use of the epoxy coating you will need to remove this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *