using Epoxy Coatings to any Garage Flooring

Often we don’t think about our garages or pay much attention to their appearance. They are simply just a destination to park the automobiles and store the excess boxes of Xmas adornments and such. However, like any other room in your own home your garage floor needs to be taken care and attention of.
Due to the make use of it gets, combined with water, gas and engine oil that will inescapable be spilled upon it, garage floor can simply become damaged and commence to break apart after a few years useful. Epoxy coating is one way to your garage floor coverings challenge. Epoxy finish applies a layer of sealant and protectant to your concrete storage area floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring requires a little up-front preparation before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy finish onto is free from moisture, residual coloring and doesn’t have a concrete sealer or other completing applied to it.
To check for moisture, take a sheet of plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting on the side of the vinyl facing the floor. If moisture exists, than an epoxy flooring coating is not suitable as epoxy requires a dried surface to properly bond with the floor coverings.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also look for the presence of natural oils in the concrete as well. Have a cup of drinking water and put it straight onto the existing flooring. It will soak into the floor in a reasonable timeframe. If it beads or simply sits on top of the flooring then the flooring has probably already been sealed or contains oil pollutants. Epoxy flooring is not suitable for cement floors which may have already been covered or contain any type of oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your garage area floor for suitability to setting up epoxy floors you can paint a small area with regular, oil-based enamel. If this test area will last for several calendar months then chances are an epoxy finish can last as well. However, if you opt to proceed with applying the epoxy covering you will need to remove this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *