using Epoxy Coatings to a Garage surface

Often we don’t think about our garages or pay much attention to the look of them. They are simply just a place to park the vehicles and store the excess boxes of Xmas adornments and such. However, like any other room in your own home your car port floor needs to be taken attention of.
Due to the utilize it gets, coupled with normal water, gas and essential oil that will unavoidable be spilled upon it, garage floors can certainly become broken and commence to fall apart over time of use. Epoxy covering is one way to your garage flooring challenge. Epoxy coating applies a part of sealant and protectant to your concrete garage area floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings takes a little up-front prep before beginning. The main step in the procedure is making sure that the floor you are going to apply the epoxy finish onto is free from moisture, residual paint and doesn’t have a cement sealer or other concluding applied to it.
To check for moisture, take a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture is present, than an epoxy floors finish is not appropriate as epoxy requires a dry surface to properly connection with the floors.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also check for the occurrence of natural oils in the cement as well. Have a cup of water and pour it immediately onto the prevailing flooring. It should soak into the floor in a reasonable amount of time. If it beads or simply sits together with the flooring then the floor coverings has probably already been sealed or contains oil contaminants. Epoxy flooring is not ideal for cement floors that contain already been covered or contain any type of oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your storage floor for suitability to installing epoxy flooring you can coloring a small area with regular, oil-based teeth enamel. If this test area can last for several months then it is likely an epoxy covering will last as well. However, if you opt to proceed with making use of the epoxy layer you will need to eliminate this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *