using Epoxy Coatings to a Garage surface

Often we don’t believe about our garages or pay much focus on their appearance. They are merely a place to park the vehicles and store the excess boxes of Xmas decor and such. However, like any other room in your house your car port floor needs to be taken good care of.
Due to the use it gets, combined with drinking water, gas and petrol that will unavoidable be spilled upon it, garage flooring can simply become destroyed and get started to break apart after a few years useful. Epoxy layer is one treatment for your garage floor coverings challenge. Epoxy coating applies a layer of sealant and protectant to your concrete car port floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings requires a little up-front planning before beginning. The most important step in the process is ensuring the ground you are going to apply the epoxy layer onto is free from moisture, residual paint and does not have a cement sealer or other concluding applied to it.
To test for moisture, take a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture exists, than an epoxy floor covering is not suited as epoxy requires a dried out surface to properly relationship with the floor.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also look for the existence of natural oils in the cement as well. Take a cup of water and pour it straight onto the prevailing flooring. It will soak in to the floor in a reasonable timeframe. If it beads or simply sits together with the flooring then the floor coverings has probably already been sealed or has oil pollutants. Epoxy floor coverings is not suited to cement floors that have already been covered or contain any type of essential oil residue as it will not bond.
Finally, if you are willing to spend several months testing an area of your garage floor for suitability to setting up epoxy floor coverings you can coloring a tiny area with regular, oil-based teeth enamel. If this test area lasts for several months then it is likely an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy covering you’ll need to eliminate this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *