application of Epoxy flooring to the Garage floor

Many times we don’t believe about our garages or pay much focus on the look of them. They are simply just a destination to park the cars and store the extra boxes of Xmas adornments and such. However, like any other room in your house your storage floor needs to be taken care and attention of.
Due to the use it gets, combined with water, gas and petrol that will unavoidable be spilled upon it, garage floor coverings may easily become destroyed and get started to fall apart after a few years of use. Epoxy finish is one solution to your garage floor challenge. Epoxy coating applies a part of sealant and protectant to your concrete car port floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front prep before beginning. The most important step in the process is ensuring the ground you are going to apply the epoxy layer onto is free from moisture, residual paint and does not have a cement sealer or other completing applied to it.
To test for moisture, have a sheet of vinyl and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting privately of the plastic material facing the floor. If moisture is present, than an epoxy floor finish is not suitable as epoxy requires a dried out surface to properly bond with the floors.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also look for the presence of natural oils in the concrete as well. Take a cup of normal water and put it straight onto the prevailing flooring. It will soak in to the floor in a reasonable amount of time. If it beads or perhaps sits on top of the flooring then your flooring has probably recently been sealed or has oil pollutants. Epoxy flooring is not well suited for cement floors which have already been sealed or contain any type of petrol residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your garage area floor for suitability to setting up epoxy floor coverings you can paint a small area with regular, oil-based teeth enamel. If this test area lasts for several a few months then it is likely an epoxy layer will last as well. However, if you opt to proceed with making use of the epoxy finish you will need to eliminate this enamel covering that may require sanding.