Do-It-Yourself car port for Epoxy System

If you’ve ever before considered utilizing a storage floor epoxy system to protect and improve the look of your garage area floor, there are a few things you need to know before purchasing one. Most diy stores take epoxy floor sets made for the do-it-yourselfer and you’ve probably heard differing thoughts on how well they work. Some will say it’s an outstanding product among others will tell you not to spend your money. Well, there is usually a fairly easy explanation as to the reasons this product fails for a few floors.
One reason behind failure is not every concrete floor is suitable for making use of an epoxy layer. Many flooring surfaces have too much hydrostatic pressure, indicating water moves from the under the slab up to the top in a process called capillary action. Moisture content then gathers on the top, which breaks the relationship between the cement and the epoxy overcoat. If the floor “sweats” even when it’s dry outside the house or there are areas that seem to be to stay moist for extended periods of time, then an epoxy layer will likely fail. It will slowly but surely chip and flake away. Even though you don’t think there is a moisture problem, it’s wise to apply an efflorescence or salt blocker before the epoxy. This will help prevent moisture content from triggering problems.

The most possible reason for inability is incorrect surface preparation. The ground must be completely clean and stripped of most other coatings. Any spots or foreign chemicals (olive oil, grease, coloring, etc.) will prevent sufficient bonding between the concrete and epoxy, leading to chipping and flaking. Most contractors will apply a layer of sealer to a car port floor after set up. It can take several years for the sealer to wear off completely. This sealer must be removed for epoxy to previous. Although acidity etching is an important step, you won’t remove sealer & most stains. Etching is only going to start the skin pores of bare concrete, therefore you should do all cleaning and stripping before etching with acid solution.

Before purchasing a storage area floor epoxy system, you will need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly moist, then forget about it. Be sure that you are prepared to take time to prep the ground properly, as this is actually the most significant part. It also really helps to put a couple of coats of clear concrete sealer on top to provide as a wear coating. Water based acrylic sealers are perfect for indoor residential use. Despite any bad reviews you’ve found out about the do-it-yourself garage area floor epoxy system, it can be a successful project if it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *