DIY storage Floor Epoxy System

If you’ve ever considered utilizing a storage area floor epoxy system to safeguard and enhance the look of your garage area floor, there are many things you need to know before purchasing one. Most home improvement stores bring epoxy floor sets suitable for the do-it-yourselfer and you might have heard differing opinions about how well they work. Some will say it’s an excellent product as well as others will tell you not to spend your money. Well, you can find usually a simple explanation as to why the product fails for a few floors.
One reason behind failure is not every concrete floor is perfect for applying an epoxy finish. Many flooring surfaces have too much hydrostatic pressure, indicating water techniques from the under the slab up to the surface in a process called capillary action. Dampness then gathers on the surface, which breaks the connection between the cement and the epoxy layer. If the ground “sweats” even though it’s dry outside or there are areas that seem to be to stay moist for long periods of time, then an epoxy coating will almost certainly fail. It’ll little by little chip and flake away. Even if you don’t think there is a moisture problem, it’s wise to apply an efflorescence or salt blocker prior to the epoxy. This will help prevent water from triggering problems.

The most possible reason for failure is incorrect surface preparation. The floor must be completely clean and stripped of most other coatings. Any discolorations or foreign chemicals (essential oil, grease, car paint, etc.) will prevent sufficient bonding between the concrete and epoxy, resulting in chipping and flaking. Most companies will apply a layer of sealer to a storage floor after assembly. Normally it takes many years for the sealer to wear off completely. This sealer must be removed for epoxy to last. Although acidity etching can be an important step, you won’t remove sealer & most stains. Etching will only start the pores of bare cement, therefore you should do all cleaning and stripping before etching with acid solution.

Before investing in a storage area floor epoxy system, you need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly moist, then just forget about it. Make sure that you are prepared to take time to prep the ground properly, as this is actually the most significant part. In addition, it helps to put a couple of coats of clear cement sealer at the top to serve as a wear jacket. Water based acrylic sealers are well suited for indoor home use. Despite any bad reviews you’ve found out about the do-it-yourself storage area floor epoxy system, it’s rather a successful project if it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *