DIY garage Floor Epoxy System

If you’ve ever before considered using a storage floor epoxy system to safeguard and enhance the look of your garage area floor, there are many things you need to understand before purchasing one. Most home improvement stores take epoxy floor products suitable for the do-it-yourselfer and you’ve probably heard differing views about how well they work. Some will say it’s an outstanding product while others will tell you not to waste your cash. Well, there is certainly usually a simple explanation as to why this product fails for some floors.
One reason for failure is not every concrete floor is suitable for making use of an epoxy covering. Many floors have too much hydrostatic pressure, indicating water goes from the under the slab up to the top in a process called capillary action. Moisture then collects on the surface, which breaks the connection between the concrete and the epoxy jacket. If the ground “sweats” even when it’s dry outside or there are areas that seem to be to stay damp for long periods of time, then an epoxy coating will almost certainly fail. It will slowly but surely chip and flake away. Even if you don’t think there’s a moisture problem, it’s a good idea to use an efflorescence or salt blocker prior to the epoxy. This will help prevent moisture content from causing problems.

The most possible reason for inability is poor surface preparation. The floor must be completely clean and stripped of most other coatings. Any stains or foreign substances (oil, grease, paint, etc.) will prevent adequate bonding between the concrete and epoxy, leading to chipping and flaking. Most contractors will apply a layer of sealer to a car port floor after set up. It can take many years for the sealer to wear off completely. This sealer must be removed for epoxy to last. Although acid solution etching can be an important step, you won’t remove sealer & most stains. Etching is only going to open up the skin pores of bare concrete, therefore you should do all cleaning and stripping before etching with acidity.

Before investing in a garage floor epoxy system, you need to first decide if your floor is right for this. If it sweats often or there are areas that are constantly damp, then forget about it. Make sure that you are prepared to take the time to prep the ground properly, as this is actually the most significant part. It also helps to put one or two coats of clear cement sealer on top to provide as a wear layer. Water based mostly acrylic sealers are well suited for indoor residential use. Despite any bad reviews you’ve heard about the do-it-yourself garage floor epoxy system, it’s rather a successful project whether it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *