DIY car port for Epoxy System

If you’ve ever before considered utilizing a garage floor epoxy system to protect and enhance the look of your garage area floor, there are a few things you have to know before purchasing one. Most diy stores carry epoxy floor products created for the do-it-yourselfer and you might have heard differing viewpoints on how well they work. Some will say it’s a fantastic product and more will tell you not to waste your money. Well, there is usually a simple explanation as to why this product fails for some floors.
One reason for failure is not every concrete floor is suitable for making use of an epoxy layer. Many floor surfaces have too much hydrostatic pressure, indicating water moves from the under the slab up to the top in an activity called capillary action. Dampness then gathers on the surface, which breaks the connection between the cement and the epoxy layer. If the ground “sweats” even when it’s dry outside or there are areas that seem to stay damp for extended periods of time, then an epoxy covering will likely fail. It’ll little by little chip and flake away. Even though you don’t think there’s a moisture problem, it’s wise to apply an efflorescence or sodium blocker before the epoxy. This will help prevent wetness from triggering problems.

The most probable reason for inability is inappropriate surface preparation. The floor must be completely clean and stripped of most other coatings. Any staining or foreign substances (olive oil, grease, coloring, etc.) will prevent sufficient bonding between the concrete and epoxy, leading to chipping and flaking. Most companies will apply a coating of sealer to a garage floor after installation. It can take several years for the sealer to wear off completely. This sealer must be removed for epoxy to last. Although acid solution etching can be an important step, it will not remove sealer and most stains. Etching is only going to open up the pores of bare concrete, therefore you should do all cleaning and stripping before etching with acidity.

Before purchasing a garage floor epoxy system, you will need to first decide if your floor is right for this. If it sweats often or there are areas that are constantly damp, then forget about it. Be sure that you are prepared to take time to prep the ground properly, as this is the most critical part. In addition, it really helps to put a couple of coats of clear concrete sealer at the top to serve as a wear layer. Water based acrylic sealers are suitable for indoor home use. Despite any bad reviews you’ve heard about the do-it-yourself car port floor epoxy system, it can be a successful project whether it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *