Applying Epoxy paint to Your Garage floor

Often we don’t believe about our garages or pay much attention to the look of them. They are simply just a location to park the automobiles and store the excess boxes of Christmas designs and such. However, like any other room in your house your car port floor needs to be taken health care of.
Due to the put it to use gets, combined with water, gas and olive oil that will inevitable be spilled after it, garage floors can certainly become broken and commence to fall apart over time useful. Epoxy finish is one solution to your garage floors challenge. Epoxy covering applies a part of sealant and protectant to your concrete car port floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor takes a little up-front preparation before beginning. The main step in the process is ensuring the floor you are going to apply the epoxy covering onto is free from moisture, residual paint and doesn’t have a cement sealer or other completing applied to it.
To check for moisture, take a sheet of vinyl and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the vinyl facing the floor. If moisture is present, than an epoxy floor coverings finish is not appropriate as epoxy needs a dried up surface to properly bond with the floors.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also look for the occurrence of oils in the cement as well. Have a cup of water and put it immediately onto the prevailing flooring. It should soak into the floor in an acceptable amount of time. If it beads or perhaps sits together with the flooring then your floor coverings has probably recently been sealed or is made up of oil contaminants. Epoxy floor is not ideal for cement floors that contain already been sealed or contain any kind of engine oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing an area of your storage floor for suitability to putting in epoxy floor you can coloring a tiny area with regular, oil-based teeth enamel. If this test area lasts for several a few months then it is likely an epoxy finish can last as well. However, if you opt to proceed with applying the epoxy finish you will need to remove this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *