Applying Epoxy paint to the Garage surface

Often we don’t think about our garages or pay much focus on their appearance. They are merely a place to park the vehicles and store the extra boxes of Christmas decor and such. However, like any other room in your own home your garage area floor must be taken treatment of.
Due to the make use of it gets, combined with drinking water, gas and engine oil that will inevitable be spilled upon it, garage floor may easily become destroyed and commence to break apart after a few years useful. Epoxy finish is one answer to your garage floor coverings challenge. Epoxy layer applies a coating of sealant and protectant to your concrete garage area floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front planning before beginning. The main step in the procedure is ensuring the ground you will apply the epoxy covering onto is free of moisture, residual color and doesn’t have a cement sealer or other completing applied to it.
To test for moisture, take a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting on the side of the vinyl facing the ground. If moisture exists, than an epoxy flooring coating is not appropriate as epoxy requires a dry out surface to properly relationship with the floor coverings.
Next, we’ll test to make certain the flooring does not have a sealant already applied to it. This test will also look for the occurrence of oils in the cement as well. Take a cup of drinking water and pour it straight onto the prevailing flooring. It should soak in to the floor in a reasonable amount of time. If it beads or simply sits on top of the flooring then the floor coverings has probably already been sealed or includes oil pollutants. Epoxy floor is not suited to cement floors which may have already been covered or contain any type of oil residue as it will not bond.
Finally, if you are prepared to spend several months testing a location of your garage area floor for suitability to installing epoxy floors you can color a little area with regular, oil-based teeth enamel. If this test area lasts for several a few months then it is likely an epoxy finish will last as well. However, if you decide to proceed with applying the epoxy layer you will need to remove this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *