Applying Epoxy paint to the Garage Flooring

Many times we don’t think about our garages or pay much attention to the look of them. They are simply just a place to park the automobiles and store the excess boxes of Xmas decorations and such. However, like any other room in your house your car port floor needs to be taken health care of.
Due to the use it gets, combined with water, gas and essential oil that will unavoidable be spilled upon it, garage flooring can certainly become harmed and start to fall apart after a few years useful. Epoxy coating is one method for your garage floor challenge. Epoxy coating applies a covering of sealant and protectant to your concrete garage area floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front prep before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy coating onto is free from moisture, residual color and does not have a cement sealer or other finishing put on it.
To test for moisture, have a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and look for any moisture collecting on the side of the clear plastic facing the ground. If moisture is present, than an epoxy floor coverings coating is not suitable as epoxy needs a dry out surface to properly relationship with the floor coverings.
Next, we’ll test to ensure the flooring doesn’t have a sealant already put on it. This test will also look for the existence of oils in the concrete as well. Have a cup of drinking water and pour it immediately onto the prevailing flooring. It will soak into the floor in a reasonable timeframe. If it beads or just sits on top of the flooring then the floor coverings has probably already been sealed or has oil pollutants. Epoxy floor coverings is not ideal for cement floors which have already been closed or contain any kind of engine oil residue as it will not bond.
Finally, if you are willing to spend several months testing an area of your garage floor for suitability to installing epoxy floor you can paint a small area with regular, oil-based teeth enamel. If this test area can last for several weeks then it is likely an epoxy covering will last as well. However, if you decide to proceed with making use of the epoxy finish you will need to remove this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *