Applying Epoxy paint to any Garage Flooring

Many times we don’t think about our garages or pay much focus on the look of them. They are simply just a place to park the cars and store the excess boxes of Xmas accessories and such. However, like any other room in your house your garage area floor needs to be taken good care of.
Because of the put it to use gets, combined with normal water, gas and essential oil that will inevitable be spilled after it, garage floor can easily become broken and start to fall apart after a few years useful. Epoxy covering is one way to your garage floor challenge. Epoxy covering applies a covering of sealant and protectant to your concrete storage area floor to make it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The main step in the procedure is ensuring the ground you will apply the epoxy layer onto is free of moisture, residual paint and does not have a concrete sealer or other finishing applied to it.
To check for moisture, take a sheet of plastic material and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and look for any moisture collecting on the side of the plastic material facing the floor. If moisture is present, than an epoxy floors coating is not appropriate as epoxy needs a dried up surface to properly relationship with the floor coverings.
Next, we’ll test to make sure the flooring does not have a sealant already applied to it. This test will also look for the occurrence of oils in the concrete as well. Take a cup of water and put it directly onto the existing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or perhaps sits together with the flooring then the flooring has probably recently been sealed or is made up of oil pollutants. Epoxy flooring is not well suited for cement floors which have already been covered or contain any kind of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your storage floor for suitability to installing epoxy floor you can paint a tiny area with regular, oil-based enamel. If this test area endures for several a few months then it is likely an epoxy finish can last as well. However, if you opt to proceed with making use of the epoxy covering you will need to remove this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *