Applying Epoxy flooring to Your Garage floors

Many times we don’t believe about our garages or pay much attention to the look of them. They are merely a place to park the autos and store the excess boxes of Christmas decorations and such. However, like any other room in your house your storage floor needs to be taken attention of.
Due to the make use of it gets, coupled with water, gas and olive oil that will unavoidable be spilled after it, garage floor may easily become damaged and get started to fall apart over time of use. Epoxy layer is one method for your garage floor challenge. Epoxy finish applies a covering of sealant and protectant to your concrete storage floor to make it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors takes a little up-front preparation before beginning. The main step in the process is ensuring the ground you will apply the epoxy layer onto is free from moisture, residual coloring and doesn’t have a cement sealer or other finishing put on it.
To test for moisture, have a sheet of vinyl and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the vinyl facing the floor. If moisture exists, than an epoxy floor coverings coating is not appropriate as epoxy requires a dry surface to properly connection with the floor.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the presence of oils in the concrete as well. Take a cup of drinking water and put it directly onto the prevailing flooring. It should soak in to the floor in a reasonable amount of time. If it beads or perhaps sits together with the flooring then the flooring has probably already been sealed or has oil pollutants. Epoxy flooring is not ideal for cement floors which may have already been covered or contain any type of petrol residue as you won’t bond.
Finally, if you are willing to spend almost a year testing a location of your car port floor for suitability to installing epoxy floors you can color a tiny area with regular, oil-based enamel. If this test area continues for several a few months then chances are an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy coating you’ll need to eliminate this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *