Applying Epoxy flooring to the Garage floors

Many times we don’t believe about our garages or pay much attention to their appearance. They are simply just a place to park the cars and store the excess boxes of Holiday decor and such. However, like any other room in your own home your car port floor must be taken attention of.
Due to the use it gets, combined with normal water, gas and oil that will unavoidable be spilled after it, garage flooring can easily become broken and start to fall apart after a few years of use. Epoxy finish is one method for your garage flooring challenge. Epoxy covering applies a part of sealant and protectant to your concrete garage area floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings requires a little up-front planning before beginning. The most important step in the procedure is ensuring the ground you will apply the epoxy finish onto is free of moisture, residual paint and doesn’t have a cement sealer or other concluding applied to it.
To test for moisture, have a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the floor. If moisture exists, than an epoxy floors covering is not appropriate as epoxy needs a dried up surface to properly connection with the floor coverings.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the presence of oils in the cement as well. Take a cup of water and put it straight onto the existing flooring. It should soak in to the floor in a reasonable timeframe. If it beads or perhaps sits together with the flooring then the floor has probably already been sealed or has oil contaminants. Epoxy floor is not ideal for cement floors which may have already been sealed or contain any type of olive oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your garage floor for suitability to installing epoxy floor coverings you can paint a small area with regular, oil-based teeth enamel. If this test area endures for several months then it is likely an epoxy layer will last as well. However, if you decide to proceed with making use of the epoxy layer you will need to remove this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *