Applying Epoxy flooring to the Garage floor

Often we don’t think about our garages or pay much attention to the look of them. They are merely a spot to park the autos and store the excess boxes of Christmas decorations and such. However, like any other room in your own home your storage floor needs to be taken treatment of.
Due to the use it gets, combined with normal water, gas and petrol that will inescapable be spilled upon it, garage floors can easily become ruined and get started to fall apart after a few years of use. Epoxy covering is one method for your garage floor coverings challenge. Epoxy coating applies a coating of sealant and protectant to your concrete storage area floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor takes a little up-front preparation before beginning. The main step in the procedure is making sure that the floor you are going to apply the epoxy coating onto is free of moisture, residual color and does not have a concrete sealer or other completing applied to it.
To test for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting on the side of the plastic facing the ground. If moisture is present, than an epoxy floor coverings layer is not suitable as epoxy requires a dry out surface to properly connection with the floors.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also check for the presence of oils in the cement as well. Take a cup of normal water and pour it directly onto the existing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or perhaps sits on top of the flooring then your floor has probably already been sealed or is made up of oil impurities. Epoxy flooring is not suitable for cement floors which have already been covered or contain any type of engine oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing an area of your storage area floor for suitability to putting in epoxy floors you can coloring a small area with regular, oil-based teeth enamel. If this test area can last for several weeks then chances are an epoxy finish will last as well. However, if you decide to proceed with applying the epoxy layer you will need to eliminate this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *