Applying Epoxy flooring to the Garage floor

Many times we don’t believe about our garages or pay much attention to their appearance. They are merely a location to park the autos and store the excess boxes of Xmas adornments and such. However, like any other room in your house your garage floor needs to be taken attention of.
Because of the utilize it gets, combined with water, gas and engine oil that will inescapable be spilled upon it, garage flooring may easily become damaged and get started to fall apart after a few years of use. Epoxy finish is one method for your garage floors challenge. Epoxy coating applies a level of sealant and protectant to your concrete car port floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring takes a little up-front planning before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy layer onto is free of moisture, residual color and doesn’t have a concrete sealer or other completing put on it.
To check for moisture, take a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting privately of the vinyl facing the floor. If moisture exists, than an epoxy floor coverings finish is not suitable as epoxy needs a dried up surface to properly bond with the floors.
Next, we’ll test to make sure the flooring does not have a sealant already applied to it. This test will also look for the presence of oils in the cement as well. Take a cup of drinking water and put it immediately onto the prevailing flooring. It should soak in to the floor in a reasonable amount of time. If it beads or maybe sits together with the flooring then the floor has probably recently been sealed or contains oil contaminants. Epoxy floors is not suited to cement floors that have already been covered or contain any kind of engine oil residue as you won’t bond.
Finally, if you are willing to spend several months testing an area of your car port floor for suitability to putting in epoxy flooring you can color a small area with regular, oil-based enamel. If this test area lasts for several months then it is likely an epoxy coating will last as well. However, if you decide to proceed with applying the epoxy layer you’ll need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *