Applying Epoxy flooring to any Garage floors

Many times we don’t think about our garages or pay much attention to the look of them. They are simply just a place to park the cars and store the excess boxes of Christmas adornments and such. However, like any other room in your house your storage area floor must be taken health care of.
Because of the use it gets, coupled with normal water, gas and engine oil that will inevitable be spilled after it, garage floors can certainly become destroyed and begin to fall apart over time of use. Epoxy layer is one treatment for your garage floor challenge. Epoxy coating applies a part of sealant and protectant to your concrete storage floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front planning before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy layer onto is free of moisture, residual paint and doesn’t have a cement sealer or other finishing applied to it.
To test for moisture, have a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting privately of the vinyl facing the ground. If moisture exists, than an epoxy floor coverings layer is not ideal as epoxy needs a dried up surface to properly relationship with the floor coverings.
Next, we’ll test to ensure the flooring doesn’t have a sealant already put on it. This test will also look for the presence of natural oils in the cement as well. Take a cup of water and put it straight onto the existing flooring. It should soak in to the floor in a reasonable amount of time. If it beads or simply sits on top of the flooring then your flooring has probably recently been sealed or is made up of oil impurities. Epoxy floor coverings is not ideal for cement floors which have already been sealed or contain any kind of essential oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing an area of your storage area floor for suitability to installing epoxy floors you can coloring a little area with regular, oil-based teeth enamel. If this test area can last for several months then it is likely an epoxy coating will last as well. However, if you decide to proceed with applying the epoxy coating you’ll need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *