Applying Epoxy flooring to a Garage floors

Often we don’t think about our garages or pay much attention to the look of them. They are simply just a location to park the vehicles and store the extra boxes of Christmas decor and such. However, like any other room in your house your garage area floor needs to be taken good care of.
Because of the use it gets, coupled with drinking water, gas and petrol that will inevitable be spilled after it, garage floors can simply become destroyed and begin to fall apart after a few years of use. Epoxy layer is one solution to your garage floor coverings challenge. Epoxy layer applies a level of sealant and protectant to your concrete storage area floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor requires a little up-front planning before beginning. The main step in the procedure is ensuring the ground you will apply the epoxy coating onto is free from moisture, residual car paint and doesn’t have a concrete sealer or other concluding put on it.
To test for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the vinyl facing the ground. If moisture exists, than an epoxy floors covering is not appropriate as epoxy requires a dried up surface to properly relationship with the floors.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the presence of oils in the concrete as well. Take a cup of water and pour it straight onto the prevailing flooring. It should soak in to the floor in a reasonable timeframe. If it beads or perhaps sits together with the flooring then your floor has probably already been sealed or includes oil pollutants. Epoxy flooring is not suited to cement floors that contain already been covered or contain any type of petrol residue as you won’t bond.
Finally, if you are prepared to spend several months testing an area of your garage area floor for suitability to setting up epoxy flooring you can color a small area with regular, oil-based enamel. If this test area will last for several a few months then chances are an epoxy covering can last as well. However, if you opt to proceed with making use of the epoxy finish you will need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *