Applying Epoxy flooring to a Garage Flooring

Many times we don’t believe about our garages or pay much attention to their appearance. They are simply just a spot to park the automobiles and store the extra boxes of Christmas decorations and such. However, like any other room in your own home your storage floor needs to be taken attention of.
Due to the use it gets, coupled with water, gas and essential oil that will inevitable be spilled after it, garage floors may easily become destroyed and commence to fall apart after a few years useful. Epoxy layer is one solution to your garage floor challenge. Epoxy coating applies a covering of sealant and protectant to your concrete garage floor to help it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor requires a little up-front planning before beginning. The main step in the procedure is making sure that the floor you are going to apply the epoxy covering onto is free of moisture, residual car paint and does not have a concrete sealer or other finishing applied to it.
To test for moisture, have a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and then remove and look for any moisture collecting privately of the plastic facing the ground. If moisture exists, than an epoxy flooring layer is not suited as epoxy requires a dried out surface to properly relationship with the floors.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also check for the occurrence of oils in the concrete as well. Take a cup of normal water and pour it directly onto the existing flooring. It should soak into the floor in a reasonable amount of time. If it beads or just sits on top of the flooring then the floor coverings has probably already been sealed or includes oil contaminants. Epoxy floor is not suited to cement floors that contain already been closed or contain any type of essential oil residue as it will not bond.
Finally, if you are prepared to spend several months testing an area of your storage area floor for suitability to setting up epoxy flooring you can coloring a small area with regular, oil-based enamel. If this test area is maintained for several a few months then chances are an epoxy finish will last as well. However, if you opt to proceed with making use of the epoxy covering you’ll need to remove this enamel finish that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *