Applying Epoxy flooring to a Garage Flooring

Many times we don’t think about our garages or pay much attention to the look of them. They are merely a spot to park the autos and store the excess boxes of Christmas decorations and such. However, like any other room in your house your storage floor needs to be taken attention of.
Because of the make use of it gets, combined with normal water, gas and engine oil that will inescapable be spilled upon it, garage floor can simply become ruined and get started to break apart after a few years useful. Epoxy finish is one means to fix your garage flooring challenge. Epoxy coating applies a covering of sealant and protectant to your concrete car port floor to make it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor requires a little up-front preparation before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy coating onto is free of moisture, residual car paint and does not have a concrete sealer or other completing applied to it.
To check for moisture, have a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two times and then remove and check for any moisture collecting on the side of the vinyl facing the floor. If moisture is present, than an epoxy floor coverings finish is not appropriate as epoxy requires a dried surface to properly bond with the floors.
Next, we’ll test to make certain the flooring does not have a sealant already applied to it. This test will also look for the existence of natural oils in the concrete as well. Have a cup of drinking water and pour it straight onto the existing flooring. It should soak into the floor in an acceptable amount of time. If it beads or perhaps sits on top of the flooring then your flooring has probably recently been sealed or is made up of oil pollutants. Epoxy floors is not ideal for cement floors which may have already been closed or contain any type of essential oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your storage area floor for suitability to putting in epoxy flooring you can color a tiny area with regular, oil-based teeth enamel. If this test area lasts for several calendar months then it is likely an epoxy coating will last as well. However, if you decide to proceed with applying the epoxy layer you’ll need to eliminate this enamel layer that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *