Applying Epoxy flooring to a Garage floor

Many times we don’t think about our garages or pay much focus on the look of them. They are merely a place to park the cars and store the excess boxes of Xmas decorations and such. However, like any other room in your house your car port floor must be taken treatment of.
Due to the use it gets, combined with water, gas and oil that will unavoidable be spilled upon it, garage flooring can simply become ruined and start to fall apart over time useful. Epoxy layer is one treatment for your garage floor challenge. Epoxy coating applies a coating of sealant and protectant to your concrete car port floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor takes a little up-front prep before beginning. The most important step in the procedure is making sure that the floor you will apply the epoxy finish onto is free of moisture, residual paint and doesn’t have a cement sealer or other concluding applied to it.
To test for moisture, take a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting privately of the plastic material facing the floor. If moisture exists, than an epoxy floor layer is not suited as epoxy needs a dry surface to properly connection with the floor coverings.
Next, we’ll test to make certain the flooring does not have a sealant already applied to it. This test will also check for the presence of oils in the cement as well. Take a cup of drinking water and pour it straight onto the existing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or perhaps sits together with the flooring then the flooring has probably recently been sealed or includes oil contaminants. Epoxy floor is not suitable for cement floors which may have already been covered or contain any type of petrol residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your garage area floor for suitability to installing epoxy floor coverings you can color a little area with regular, oil-based teeth enamel. If this test area lasts for several a few months then it is likely an epoxy covering can last as well. However, if you decide to proceed with applying the epoxy finish you will need to eliminate this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *