Applying Epoxy Coatings to the Garage floors

Many times we don’t believe about our garages or pay much focus on their appearance. They are merely a location to park the cars and store the excess boxes of Holiday adornments and such. However, like any other room in your house your garage area floor must be taken good care of.
Due to the put it to use gets, combined with normal water, gas and essential oil that will unavoidable be spilled after it, garage floor can simply become broken and start to break apart over time useful. Epoxy finish is one treatment for your garage flooring challenge. Epoxy coating applies a layer of sealant and protectant to your concrete garage floor to help it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors takes a little up-front planning before beginning. The main step in the procedure is ensuring the floor you are going to apply the epoxy covering onto is free from moisture, residual coloring and does not have a cement sealer or other finishing applied to it.
To check for moisture, have a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting on the side of the plastic material facing the floor. If moisture is present, than an epoxy floor coverings coating is not appropriate as epoxy needs a dried up surface to properly connection with the flooring.
Next, we’ll test to ensure the flooring doesn’t have a sealant already put on it. This test will also check for the occurrence of oils in the cement as well. Have a cup of normal water and put it immediately onto the existing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or simply sits on top of the flooring then the floors has probably already been sealed or has oil pollutants. Epoxy flooring is not suited to cement floors that contain already been covered or contain any kind of petrol residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your car port floor for suitability to putting in epoxy floor you can color a little area with regular, oil-based teeth enamel. If this test area will last for several months then chances are an epoxy finish can last as well. However, if you decide to proceed with making use of the epoxy coating you’ll need to eliminate this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *