Applying Epoxy Coatings to a Garage floor

Many times we don’t think about our garages or pay much focus on the look of them. They are merely a spot to park the cars and store the extra boxes of Xmas decorations and such. However, like any other room in your own home your garage floor must be taken care of.
Because of the put it to use gets, combined with drinking water, gas and engine oil that will unavoidable be spilled after it, garage flooring may easily become ruined and begin to break apart after a few years of use. Epoxy finish is one solution to your garage floor coverings challenge. Epoxy coating applies a coating of sealant and protectant to your concrete garage area floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring requires a little up-front preparation before beginning. The most important step in the procedure is making sure that the ground you will apply the epoxy layer onto is free of moisture, residual color and does not have a cement sealer or other concluding applied to it.
To test for moisture, have a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting on the side of the clear plastic facing the floor. If moisture is present, than an epoxy floor layer is not appropriate as epoxy requires a dried out surface to properly connection with the floor coverings.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also check for the occurrence of oils in the concrete as well. Take a cup of normal water and put it straight onto the prevailing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or simply sits on top of the flooring then your floor has probably recently been sealed or includes oil contaminants. Epoxy flooring is not ideal for cement floors that contain already been covered or contain any type of oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your storage floor for suitability to putting in epoxy floor you can color a little area with regular, oil-based enamel. If this test area lasts for several months then it is likely an epoxy layer will last as well. However, if you decide to proceed with applying the epoxy covering you’ll need to remove this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *