Applying Epoxy Coatings to a Garage floor

Often we don’t believe about our garages or pay much focus on the look of them. They are merely a destination to park the autos and store the extra boxes of Holiday designs and such. However, like any other room in your own home your garage floor must be taken attention of.
Because of the make use of it gets, coupled with normal water, gas and olive oil that will inescapable be spilled after it, garage floor coverings can simply become broken and get started to fall apart over time of use. Epoxy layer is one answer to your garage floor coverings challenge. Epoxy layer applies a level of sealant and protectant to your concrete garage floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring takes a little up-front prep before beginning. The most important step in the procedure is ensuring the ground you are going to apply the epoxy finish onto is free from moisture, residual paint and doesn’t have a cement sealer or other finishing put on it.
To check for moisture, take a sheet of plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture exists, than an epoxy flooring layer is not suitable as epoxy needs a dried surface to properly bond with the floor coverings.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the presence of natural oils in the cement as well. Have a cup of normal water and pour it immediately onto the prevailing flooring. It will soak in to the floor in a reasonable timeframe. If it beads or maybe sits on top of the flooring then your floor has probably already been sealed or consists of oil pollutants. Epoxy floors is not suited to cement floors that have already been covered or contain any kind of engine oil residue as you won’t bond.
Finally, if you are willing to spend several months testing a location of your storage area floor for suitability to setting up epoxy flooring you can color a tiny area with regular, oil-based teeth enamel. If this test area continues for several calendar months then chances are an epoxy covering can last as well. However, if you opt to proceed with making use of the epoxy covering you will need to eliminate this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *