Applying Epoxy Coatings to a Garage floor

Many times we don’t think about our garages or pay much focus on their appearance. They are simply just a place to park the autos and store the extra boxes of Christmas accessories and such. However, like any other room in your house your storage area floor needs to be taken care and attention of.
Due to the make use of it gets, combined with water, gas and petrol that will unavoidable be spilled after it, garage flooring may easily become ruined and get started to break apart over time useful. Epoxy finish is one way to your garage flooring challenge. Epoxy covering applies a covering of sealant and protectant to your concrete garage floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor requires a little up-front planning before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy coating onto is free of moisture, residual color and does not have a concrete sealer or other finishing put on it.
To check for moisture, have a sheet of plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and look for any moisture collecting privately of the clear plastic facing the ground. If moisture exists, than an epoxy floors coating is not ideal as epoxy needs a dried out surface to properly relationship with the floor coverings.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of water and pour it immediately onto the existing flooring. It will soak in to the floor in a reasonable amount of time. If it beads or perhaps sits on top of the flooring then the floors has probably recently been sealed or includes oil contaminants. Epoxy floor is not suitable for cement floors which have already been covered or contain any type of olive oil residue as it will not bond.
Finally, if you are prepared to spend several months testing a location of your garage area floor for suitability to putting in epoxy floor coverings you can paint a tiny area with regular, oil-based teeth enamel. If this test area endures for several calendar months then chances are an epoxy finish can last as well. However, if you opt to proceed with applying the epoxy finish you will need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *