application of Epoxy paint to Your Garage Flooring

Often we don’t believe about our garages or pay much focus on their appearance. They are merely a destination to park the cars and store the extra boxes of Xmas decor and such. However, like any other room in your house your storage floor needs to be taken care and attention of.
Because of the put it to use gets, combined with drinking water, gas and oil that will inevitable be spilled after it, garage floor coverings can easily become ruined and get started to fall apart after a few years of use. Epoxy coating is one solution to your garage floors challenge. Epoxy finish applies a covering of sealant and protectant to your concrete garage floor to make it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring requires a little up-front preparation before beginning. The main step in the procedure is making sure that the ground you will apply the epoxy coating onto is free from moisture, residual car paint and does not have a concrete sealer or other finishing applied to it.
To test for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two times and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture is present, than an epoxy floor coverings layer is not suitable as epoxy requires a dried out surface to properly bond with the floor coverings.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also look for the occurrence of oils in the concrete as well. Take a cup of water and pour it directly onto the existing flooring. It should soak into the floor in a reasonable timeframe. If it beads or simply sits together with the flooring then the floor coverings has probably already been sealed or contains oil contaminants. Epoxy floors is not suited to cement floors which may have already been covered or contain any kind of engine oil residue as you won’t bond.
Finally, if you are willing to spend several months testing a location of your storage floor for suitability to installing epoxy floor coverings you can paint a little area with regular, oil-based enamel. If this test area lasts for several a few months then it is likely an epoxy coating can last as well. However, if you decide to proceed with applying the epoxy covering you’ll need to remove this enamel finish that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *