application of Epoxy paint to Your Garage floor

Many times we don’t believe about our garages or pay much attention to the look of them. They are merely a place to park the cars and store the excess boxes of Xmas designs and such. However, like any other room in your house your garage floor needs to be taken treatment of.
Because of the utilize it gets, coupled with normal water, gas and olive oil that will unavoidable be spilled after it, garage flooring can certainly become damaged and begin to break apart after a few years useful. Epoxy finish is one treatment for your garage flooring challenge. Epoxy coating applies a covering of sealant and protectant to your concrete car port floor to help it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring takes a little up-front preparation before beginning. The most important step in the process is making sure that the floor you will apply the epoxy covering onto is free from moisture, residual coloring and does not have a cement sealer or other concluding put on it.
To test for moisture, have a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting on the side of the plastic material facing the floor. If moisture exists, than an epoxy floors finish is not ideal as epoxy requires a dry out surface to properly connection with the floor.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also look for the existence of natural oils in the cement as well. Take a cup of drinking water and put it directly onto the existing flooring. It should soak in to the floor in an acceptable amount of time. If it beads or maybe sits on top of the flooring then your flooring has probably recently been sealed or contains oil pollutants. Epoxy floors is not suited to cement floors which may have already been sealed or contain any type of oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing a location of your car port floor for suitability to putting in epoxy flooring you can color a small area with regular, oil-based enamel. If this test area is maintained for several a few months then it is likely an epoxy covering will last as well. However, if you decide to proceed with applying the epoxy layer you’ll need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *