application of Epoxy paint to the Garage surface

Often we don’t believe about our garages or pay much attention to their appearance. They are merely a destination to park the automobiles and store the excess boxes of Holiday adornments and such. However, like any other room in your own home your garage area floor must be taken treatment of.
Because of the utilize it gets, coupled with drinking water, gas and oil that will inevitable be spilled upon it, garage floor can simply become ruined and begin to fall apart after a few years of use. Epoxy finish is one way to your garage floors challenge. Epoxy layer applies a level of sealant and protectant to your concrete garage area floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front preparation before beginning. The main step in the process is making sure that the floor you will apply the epoxy layer onto is free from moisture, residual coloring and does not have a concrete sealer or other concluding put on it.
To check for moisture, take a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture exists, than an epoxy flooring finish is not suited as epoxy requires a dried out surface to properly relationship with the flooring.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the existence of oils in the concrete as well. Take a cup of water and put it directly onto the prevailing flooring. It should soak in to the floor in a reasonable amount of time. If it beads or perhaps sits together with the flooring then the floor has probably already been sealed or has oil pollutants. Epoxy flooring is not suitable for cement floors which may have already been sealed or contain any kind of petrol residue as it will not bond.
Finally, if you are prepared to spend several months testing a location of your storage area floor for suitability to putting in epoxy flooring you can paint a little area with regular, oil-based enamel. If this test area continues for several weeks then chances are an epoxy coating can last as well. However, if you opt to proceed with applying the epoxy finish you will need to remove this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *