application of Epoxy paint to the Garage floors

Often we don’t believe about our garages or pay much focus on their appearance. They are merely a place to park the autos and store the excess boxes of Christmas designs and such. However, like any other room in your own home your car port floor must be taken care of.
Due to the put it to use gets, coupled with normal water, gas and essential oil that will inescapable be spilled after it, garage floor coverings may easily become damaged and get started to fall apart after a few years useful. Epoxy coating is one answer to your garage flooring challenge. Epoxy finish applies a level of sealant and protectant to your concrete garage floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings takes a little up-front preparation before beginning. The main step in the process is ensuring the floor you are going to apply the epoxy layer onto is free of moisture, residual coloring and does not have a cement sealer or other completing applied to it.
To check for moisture, take a sheet of plastic material and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two times and then remove and check for any moisture collecting on the side of the plastic material facing the floor. If moisture is present, than an epoxy floor coverings covering is not suitable as epoxy requires a dried surface to properly connection with the flooring.
Next, we’ll test to make certain the flooring does not have a sealant already applied to it. This test will also look for the occurrence of oils in the cement as well. Have a cup of normal water and put it directly onto the existing flooring. It will soak into the floor in an acceptable amount of time. If it beads or maybe sits together with the flooring then your floors has probably already been sealed or contains oil impurities. Epoxy floor coverings is not well suited for cement floors which have already been closed or contain any type of engine oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing an area of your car port floor for suitability to putting in epoxy floor you can coloring a small area with regular, oil-based teeth enamel. If this test area will last for several a few months then it is likely an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy finish you will need to remove this enamel layer that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *