application of Epoxy paint to any Garage surface

Many times we don’t think about our garages or pay much attention to the look of them. They are simply just a place to park the cars and store the excess boxes of Xmas decorations and such. However, like any other room in your house your storage area floor must be taken health care of.
Due to the make use of it gets, combined with normal water, gas and olive oil that will unavoidable be spilled upon it, garage floors can easily become destroyed and get started to break apart over time of use. Epoxy layer is one method for your garage flooring challenge. Epoxy finish applies a layer of sealant and protectant to your concrete garage floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor takes a little up-front prep before beginning. The main step in the procedure is making sure that the ground you are going to apply the epoxy finish onto is free of moisture, residual color and doesn’t have a concrete sealer or other concluding put on it.
To test for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting on the side of the plastic facing the floor. If moisture exists, than an epoxy floors layer is not ideal as epoxy needs a dried surface to properly relationship with the floor coverings.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also look for the presence of natural oils in the concrete as well. Have a cup of normal water and put it straight onto the prevailing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or maybe sits on top of the flooring then the floors has probably recently been sealed or is made up of oil impurities. Epoxy floors is not suitable for cement floors which have already been closed or contain any type of engine oil residue as it will not bond.
Finally, if you are willing to spend several months testing a location of your car port floor for suitability to installing epoxy floor you can coloring a small area with regular, oil-based enamel. If this test area is maintained for several a few months then chances are an epoxy layer will last as well. However, if you opt to proceed with applying the epoxy layer you’ll need to eliminate this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *