application of Epoxy paint to any Garage Flooring

Many times we don’t believe about our garages or pay much focus on their appearance. They are merely a place to park the autos and store the extra boxes of Holiday accessories and such. However, like any other room in your house your storage floor needs to be taken treatment of.
Because of the make use of it gets, coupled with normal water, gas and petrol that will inevitable be spilled after it, garage floors may easily become destroyed and begin to break apart after a few years useful. Epoxy layer is one answer to your garage floor coverings challenge. Epoxy finish applies a level of sealant and protectant to your concrete garage area floor to make it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front planning before beginning. The most important step in the procedure is making sure that the ground you will apply the epoxy layer onto is free from moisture, residual color and does not have a cement sealer or other completing put on it.
To check for moisture, have a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting privately of the clear plastic facing the floor. If moisture exists, than an epoxy flooring layer is not ideal as epoxy requires a dry surface to properly relationship with the flooring.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also check for the presence of oils in the concrete as well. Have a cup of normal water and put it directly onto the existing flooring. It will soak into the floor in an acceptable amount of time. If it beads or just sits on top of the flooring then your floor coverings has probably already been sealed or is made up of oil contaminants. Epoxy floor is not suited to cement floors which may have already been covered or contain any kind of engine oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your car port floor for suitability to setting up epoxy floor coverings you can paint a small area with regular, oil-based enamel. If this test area can last for several calendar months then chances are an epoxy coating will last as well. However, if you opt to proceed with applying the epoxy layer you’ll need to remove this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *