application of Epoxy flooring to the Garage surface

Often we don’t think about our garages or pay much attention to their appearance. They are simply just a place to park the cars and store the extra boxes of Xmas accessories and such. However, like any other room in your own home your garage area floor must be taken good care of.
Because of the utilize it gets, coupled with water, gas and oil that will inevitable be spilled upon it, garage floor can easily become damaged and begin to fall apart over time useful. Epoxy layer is one treatment for your garage floor coverings challenge. Epoxy coating applies a level of sealant and protectant to your concrete storage area floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors requires a little up-front preparation before beginning. The main step in the process is making sure that the ground you are going to apply the epoxy layer onto is free of moisture, residual coloring and doesn’t have a cement sealer or other concluding applied to it.
To test for moisture, have a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting privately of the vinyl facing the ground. If moisture exists, than an epoxy floors covering is not suitable as epoxy requires a dry surface to properly relationship with the flooring.
Next, we’ll test to make sure the flooring does not have a sealant already applied to it. This test will also look for the existence of oils in the cement as well. Have a cup of water and put it directly onto the prevailing flooring. It should soak into the floor in a reasonable amount of time. If it beads or perhaps sits on top of the flooring then your floor coverings has probably recently been sealed or has oil contaminants. Epoxy floor coverings is not ideal for cement floors which may have already been closed or contain any kind of petrol residue as it will not bond.
Finally, if you are willing to spend almost a year testing a location of your car port floor for suitability to setting up epoxy floor you can coloring a little area with regular, oil-based teeth enamel. If this test area is maintained for several a few months then chances are an epoxy layer can last as well. However, if you opt to proceed with applying the epoxy finish you’ll need to eliminate this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *