application of Epoxy flooring to the Garage surface

Often we don’t think about our garages or pay much attention to their appearance. They are merely a place to park the automobiles and store the extra boxes of Christmas decor and such. However, like any other room in your house your storage floor must be taken health care of.
Due to the use it gets, coupled with normal water, gas and engine oil that will unavoidable be spilled after it, garage floor coverings can simply become destroyed and start to fall apart after a few years useful. Epoxy finish is one method for your garage floor challenge. Epoxy covering applies a coating of sealant and protectant to your concrete garage floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front planning before beginning. The main step in the procedure is making sure that the ground you will apply the epoxy covering onto is free from moisture, residual paint and does not have a concrete sealer or other concluding put on it.
To test for moisture, have a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the vinyl facing the floor. If moisture is present, than an epoxy flooring covering is not suited as epoxy requires a dried surface to properly bond with the flooring.
Next, we’ll test to make sure the flooring does not have a sealant already applied to it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of normal water and put it directly onto the existing flooring. It will soak into the floor in a reasonable amount of time. If it beads or perhaps sits together with the flooring then the floor has probably already been sealed or contains oil contaminants. Epoxy floor coverings is not suitable for cement floors which may have already been covered or contain any kind of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your storage floor for suitability to installing epoxy floors you can color a tiny area with regular, oil-based teeth enamel. If this test area continues for several calendar months then chances are an epoxy layer will last as well. However, if you opt to proceed with applying the epoxy layer you’ll need to eliminate this enamel finish that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *