application of Epoxy flooring to any Garage surface

Often we don’t believe about our garages or pay much focus on the look of them. They are merely a place to park the autos and store the excess boxes of Xmas designs and such. However, like any other room in your own home your storage area floor needs to be taken good care of.
Due to the make use of it gets, coupled with drinking water, gas and engine oil that will inevitable be spilled upon it, garage floor can certainly become damaged and get started to break apart over time of use. Epoxy coating is one solution to your garage floors challenge. Epoxy coating applies a layer of sealant and protectant to your concrete garage floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The most important step in the procedure is ensuring the floor you will apply the epoxy covering onto is free of moisture, residual coloring and doesn’t have a cement sealer or other completing applied to it.
To test for moisture, take a sheet of plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting on the side of the plastic facing the ground. If moisture is present, than an epoxy flooring coating is not suitable as epoxy requires a dry out surface to properly relationship with the floor.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the existence of natural oils in the cement as well. Have a cup of water and pour it directly onto the prevailing flooring. It should soak into the floor in a reasonable amount of time. If it beads or simply sits on top of the flooring then the floor has probably recently been sealed or is made up of oil impurities. Epoxy floors is not well suited for cement floors that contain already been covered or contain any kind of essential oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your car port floor for suitability to setting up epoxy floor coverings you can paint a tiny area with regular, oil-based enamel. If this test area endures for several months then it is likely an epoxy covering will last as well. However, if you opt to proceed with making use of the epoxy finish you’ll need to remove this enamel covering that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *